VeriFone Printer 900 Installationsanleitung

Printer 900Installation Guide

Running thePrint Test 1. Disconnect the power cord at the rear of the printer.2. Hold down the paper feed button and plug the powercord back into the

Printer SpecificationsPowerRequirementsVoltage: 90 VAC–137 VAC, 47–60 Hz (low voltage version)180 VAC–274 VAC, 47–60 Hz (high voltage version)Power c

AccessoriesVeriFonePart No. DescriptionRibbonCartridgesCRM0023 Red/BlackCRM0025 PurpleRoll paper CRM0008-01 Paper, 11 mm core 2-ply P250/500/900RCRM0

Table of ContentsIntroduction ...3Key Featu

IntroductionThe Printer 900 is a high-performance, freestandingdot-matrix roll printer for VeriFone terminals or computersequipped with anRS-232 seria

Figure 1. Printer 900 Components2. Place the printer on a solid desk or table top. Whenchoosing a location for the printer, avoid areas with• direct s

Setting the Internal DIP SwitchesA set of four DIP switches is located under the paperholder on the bottom of your Printer 900. Make sure thatthese s

Installing the Printer 900CAUTION: Unplug the terminal’s power pack before con-necting the Printer 900 to the terminal.Before installing the Printer 9

Installing orReplacing theRibbonCartridge1. Remove the ribbon cover by pressing the front tab andlifting the cover up.2. If you are replacing an old r

Installing thePaper RollThe Printer 900 accepts paper that is 76mm wide. Thereare three different types of roll paper available fromVeriFone. These

Figure 8. Installing the Paper Roll (exploded view)RollCoverPaperRollPaper Feed ButtonPaper SupportArmsPaper Roll CorePaper CavityPaper FeedPathTo eng